); SAEximRunCond expanded to false Errors-To: [EMAIL PROTECTED] RETRY Hello everyone,
I was hacking away at the Fury and I decided that I needed an interface board to go along with it. So, I fired up my capture/layout program and so far this is what I have: First, the Fury board will attach to the interface board via 2 SMA connectors. The interface board will have holes to accommodate connectors for the HP 10544A, 10811A/B and 10811A-6011 OCXO. Including the 2 mounting screws. I also have this OCXO: http://www.crystekcrystals.com/crystal/spec-sheets/ocxo/CO27VS12DE-02-10_000.pdf So I would have the holes there for this device as well. I also need BNC connectors for the 10MHz sine wave and 1PPS. The board would need 24VDC and have regulators for 12V. 24VDC is needed by the HP oscillators. I'd like to see if the members of time-nuts would be interested in such a board. If so, I would make a production run for them. Standard 4 layer RoHS. It would be 6-8 weeks until delivery. Any suggestions are very much welcome. -George _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
