); SAEximRunCond expanded to false Errors-To: [EMAIL PROTECTED] RETRY I'd be interested in one, George.
John ---- [EMAIL PROTECTED] said the following on 10/22/2007 05:39 PM: > ); SAEximRunCond expanded to false > Errors-To: [EMAIL PROTECTED] RETRY > > Hello everyone, > > I was hacking away at the Fury and I decided that I needed an > interface board to go along with it. > > So, I fired up my capture/layout program and so far this is what I have: > > First, the Fury board will attach to the interface board via 2 SMA connectors. > > The interface board will have holes to accommodate connectors for the > HP 10544A, 10811A/B and 10811A-6011 OCXO. Including the 2 mounting > screws. > > I also have this OCXO: > > http://www.crystekcrystals.com/crystal/spec-sheets/ocxo/CO27VS12DE-02-10_000.pdf > > So I would have the holes there for this device as well. > > I also need BNC connectors for the 10MHz sine wave and 1PPS. > > The board would need 24VDC and have regulators for 12V. 24VDC is > needed by the HP oscillators. > > I'd like to see if the members of time-nuts would be interested in > such a board. > > If so, I would make a production run for them. Standard 4 layer RoHS. > It would be 6-8 weeks until delivery. > > Any suggestions are very much welcome. > > -George > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
