I think the max for the FRS is 5.5v into 50ohms.
Scott
[EMAIL PROTECTED] wrote:
> Hi Scott,
>
> I don't have access to the Fury schematics right now, but I believe the Fury
> 10MHz input is 50 Ohms terminated, so the TTL output would have to be able
> to supply that load.
>
> No other side effect, just make sure to adhere to the maximum input power
> level (+13dBm I believe), even for TTL.
>
> Hope that helps,
> bye,
> Said
>
>
> In a message dated 4/11/2008 11:20:25 Pacific Daylight Time, [EMAIL
> PROTECTED]
> writes:
>
> The output of the Rb was TTL also. What are the side effects
> of using that with the Fury (other than not getting a sine output)?
>
>
>
>
> **************Planning your summer road trip? Check out AOL Travel Guides.
> (http://travel.aol.com/travel-guide/united-states?ncid=aoltrv00030000000016)
> _______________________________________________
> time-nuts mailing list -- [email protected]
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
