Hi Bruce, Ulrich, thanks for the pointers, since jitter/phase noise is not an issue on the 10MHz for this project, I will probably settle for the full-bridge rectifier diode frequency doubler. I have got a bunch of Macom ETC1-1-13 transformers laying around that would probably do the job well. thanks again, Said In a message dated 4/20/2008 21:47:11 Pacific Daylight Time, [EMAIL PROTECTED] writes:
If you want better performance than the 5370 frequency multiplier chain you should use a low phase noise frequency multiplier such as one of those listed or depicted at: http://www.eds-fl.com/~bruce/FrequencyMultipliers.html <http://www.eds-fl.com/%7Ebruce/FrequencyMultipliers.html> Bruce **************Need a new ride? Check out the largest site for U.S. used car listings at AOL Autos. (http://autos.aol.com/used?NCID=aolcmp00300000002851) _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
