Arnold Thanks for the picture/schematic , this is the item in question, and I can see that it comes from a 5328A manual ! - obviously a different issue from the one on the Agilent website. I gather that the 10544A is another Xtal Osc. module ? - is there compatibility between the two ?? regards
Roy ----- Original Message ----- From: "Arnold Tibus" <[EMAIL PROTECTED]> To: "Discussion of precise time and frequency measurement" <[email protected]> Sent: Wednesday, May 28, 2008 11:13 AM Subject: Re: [time-nuts] The HP 10811-60111 > Roy, > may I help with the copy I have? > Unfortunately I do not remember the friendly person who > published it in the net. > The board seem to be designed to run the 10544A > but may serve as well for the 10811A. > > regards > Arnold Tibus > > > On Wed, 28 May 2008 10:34:42 +0100, Roy Phillips wrote: > >>Good members > >>I have a 10811-60111 Crystal Osc. which is attached (15 way edge >>connector), to a PCB of Hewlett Packard manufacture. This later item has a >>type number 05328-20027 which suggests that it was part of the HP > 5328 Counter. The PCB is about half as big again as the XTAL Osc., and has > 4 IC's, 3 transistors, a "fine adjust" pot, and 2 adjustable C's (C12 & > C15), and finally a 15 way identical edge connector. Rick pointed me to > the Agilent "old equipment" site to download the 5328 Manual. This > unfortunately does not have this unit within, but shows a simple smaller > interface. It is obviously a complete control interface - ?oscillator and > oven? . If > anyone has the data on this unit I would be most grateful for a copy, in > particular the edge connector, interconnections and set-up data. > >>Roy Phillips > > >>_______________________________________________ >>time-nuts mailing list -- [email protected] >>To unsubscribe, go to >>https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>and follow the instructions there. > > > -------------------------------------------------------------------------------- > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
