That would be a lot quiter than a fan.... may have to give that a try. -----Original Message----- From: [email protected] [mailto:[email protected]]on Behalf Of Don Latham Sent: Saturday, May 23, 2009 4:48 PM To: Discussion of precise time and frequency measurement Subject: Re: [time-nuts] more 5370B
I had a similar heat problem with another hp of the same vintage. i clamped another heatsink on with some cheap 1 in c-clamps. cooled it off pretty well. don Mark Sims > > I measured one of my units. Room temp is 23.5C, hottest spot on the heat > sink is 58.5C. A rise of 35C over ambient. Your 140F temperature reading > is, unfortunately, quite normal. I have considered adding a small fan > to the heat sink. These numbers might just prompt me to get off my duff > and do so... > > > > _________________________________________________________________ > Insert movie times and more without leaving Hotmail®. > http://windowslive.com/Tutorial/Hotmail/QuickAdd?ocid=TXT_TAGLM_WL_HM_Tutori al_QuickAdd1_052009 > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > -- Dr. Don Latham AJ7LL Six Mile Systems LLP 17850 Six Mile Road POB 134 Huson, MT, 59846 VOX 406-626-4304 www.lightningforensics.com www.sixmilesystems.com _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
