I have to fill the Trimble Bullet III into the list of antennas with this thread. Here are some mounting adapters shown: http://www.dpie.com/gps/bullet3.html
Arnold On Tue, 7 Jul 2009 15:23:42 +0100, David C. Partridge wrote: >I think it is also known as 3/4" NPT for a pipe with a nominal OD of 1.05" >Dave >-----Original Message----- >From: [email protected] [mailto:[email protected]] On >Behalf Of David C. Partridge >Sent: 07 July 2009 14:54 >To: 'Discussion of precise time and frequency measurement' >Subject: Re: [time-nuts] 1" 14 tpi UNS die >This is the standard Marine antenna mount I believe. >Dave >-----Original Message----- >From: [email protected] [mailto:[email protected]] On >Behalf Of David C. Partridge >Sent: 07 July 2009 14:47 >To: 'Discussion of precise time and frequency measurement' >Subject: Re: [time-nuts] 1" 14 tpi UNS die ><http://pewa.panasonic.com/emp/products/gps_pdf/vic100.pdf> is where I got >the specification for the thread from. >Pipe has O.D. of 1". >Dave >-----Original Message----- >From: [email protected] [mailto:[email protected]] On >Behalf Of Chuck Harris >Sent: 07 July 2009 13:57 >To: Discussion of precise time and frequency measurement >Subject: Re: [time-nuts] 1" 14 tpi UNS die >Ok, I will try this from a different angle. >1" - 14TPI UNS thread like you described are very rare outside of the large >machine industry. They are used for things like bolts on tractors. I have >a pretty big doubt that it has any application in a GPS antenna. >US pipe thread in the sizes 1/2", 3/4", and 1" are 14TPI, they are not "1.0 >inch" in any dimension, however. >It is pretty common to use standard pipe fittings in antenna work. >So how did you arrive at needing a 1"-14TPI UNS die? >-Chuck Harris >David C. Partridge wrote: >> Panasonic VIC-100 GPS antenna ... >> >> Dave >> >> -----Original Message----- >> From: [email protected] [mailto:[email protected]] >> On Behalf Of Chuck Harris >> Sent: 07 July 2009 13:07 >> To: Discussion of precise time and frequency measurement >> Subject: Re: [time-nuts] 1" 14 tpi UNS die >> >> I don't recognize the size you are asking for. What is your application? >> >> -Chuck Harris >> >> David C. Partridge wrote: >>> Does anyone (preferably in the UK) have 1.0-14UNS-2A thread cutting >>> die they would be prepared to lend me (preferably a die nut type as I >>> don't have a die stock)? >>> >>> Thanks >>> David Partridge _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
