Thanks guys,
It is up and running now.
I dont know if I had not addressed it properly re. COM port or speed
or if the battery needed time to charge or the right button had to be
clicked,
but after messing with it for some time it came good.
thanks,
Neville Michie
On 31/10/2009, at 11:53 PM, Pascal Nguyen wrote:
Suppose your 17 HVS having flat backup battery, once power up, by
default, it goes to Garmin mode.
You need to run the setup with:
SNSRCFG
http://www8.garmin.com/support/collection.jsp?product=010-00242-53
Reconfigure the 17 to NMEA mode
Chao,
Pascal
On 10/31/09, mike cook <[email protected]> wrote:
A stab in the dark. I don't have one of these.
The doc I find says that these are supplied with a rechargable
lithium cell
which enables back up of GPS data . It is supposed to last 10yrs,
so if
yours is reaching retirement age it may have gone awol and dropped
the
serial parameters to a state which your monitor is not set too.
So you could try all the baud rates listed in the specs. Use a
terminal
emulator instead of the monitor program, which appears to be a
graphic app,
to see if you getting any data output .
default appears to be 9600,8 bit,no parity
Serial Interfaces
a.. Port 1: True RS-232 output, asynchronous serial input
compatible with
RS-232 or TTL voltage levels, RS-232 polarity
b.. Port 2: Asynchronous serial input only, compatible with
RS-232 or TTL
voltage levels, RS-232 polarity
c.. Baud Rates
d.. 300/600/1200/2400/4800/9600/19200
e..
Serial Formats
a.. Port 1: Selectable between NMEA 0183 v2.00, NMEA 0183 v3.00,
and
Garmin® binary formats; NMEA 0183 v2.0 (ASCII); Approved output
sentences:
GPALM, GPGGA, GPGLL, GPGSA, GPGSV, GPRMC, GPVTG; Proprietary
sentences:
PGRMB, PGRME, PGRMF, PGRMM, PGRMT, PGRMV
----- Original Message -----
From: "Neville Michie" <[email protected]>
To: "Discussion of precise time and frequency measurement"
<[email protected]>
Sent: Saturday, October 31, 2009 9:15 AM
Subject: [time-nuts] Garmin GPS17
Hello all,
I have a Garmin GPS17 HVS which is a GPS receiver/antenna in one
unit.
When I first bought it I used it to discipline an HP10811 OCXO.
One day
it stopped
responding to its monitor program.
I got a TBOLT which has kept me busy and now I want to compare it
to the
Garmin.
Although I used to be able to run the monitor program and it does
not
respond any more,
if you put it under the sky and power it up, after a while you
get a PPS
out of it that is
in phase with the GPS.
So there is somebody home but they have turned out the lights.
The Garmin manuals mention failure to respond if you do the wrong
thing,
Can anyone help me get it going again?
Cheers,
Neville Michie
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/
time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
