Alas, there is no way to get a direct conversion between AMU and dBc. What
you have to do is display the signal levels in dBc and then switch the unit to
AMU. It takes it a couple of seconds before it switches. By then the signal
levels have changed, so that the data is only approximate. The lower signal
levels seem to change the most so I have been unable to get any
reliable/repeatable readings.
Even setting the AMU mask level and watching where sats turn yellow/green does
not work well. There appears to be some hysterisis/filtering/delay in the
selection/deselection process.
----------------
Can you also see what 0.0, 0.5, 1.0, 1.5, 2.5, 3.0 are equal to.
Those are the important ones when setting the AMU lower.
_________________________________________________________________
Hotmail: Trusted email with powerful SPAM protection.
http://clk.atdmt.com/GBL/go/177141665/direct/01/
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
