Compare 2 each T'Bolts with V3.0 Firmware, all on a common antenna
Set one to read AMU's, set the other to read dBc.
May make a reasonable comparison.
Probably would be best to compare with both set to AMU readings,
then both set for dBc readings, to be sure there is some close agreement.
Then set one to AMU and the other to dBc. Compare/document.
Stan, W1LE Cape Cod
Mark Sims wrote:
Alas, there is no way to get a direct conversion between AMU and dBc. What
you have to do is display the signal levels in dBc and then switch the unit to
AMU. It takes it a couple of seconds before it switches. By then the signal
levels have changed, so that the data is only approximate. The lower signal
levels seem to change the most so I have been unable to get any
reliable/repeatable readings.
Even setting the AMU mask level and watching where sats turn yellow/green does
not work well. There appears to be some hysterisis/filtering/delay in the
selection/deselection process.
----------------
Can you also see what 0.0, 0.5, 1.0, 1.5, 2.5, 3.0 are equal to.
Those are the important ones when setting the AMU lower.
_________________________________________________________________
Hotmail: Trusted email with powerful SPAM protection.
http://clk.atdmt.com/GBL/go/177141665/direct/01/
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
