Before any body gets upset, I said before I used the wrong price calculator. The present mixer/counter takes up 4.3 by 5.3 inches, can be separated into two boards and in 100 qty would be $ 9.60 with silk screen and solder mask. Bert Kehren In a message dated 1/25/2010 12:10:43 P.M. Eastern Standard Time, [email protected] writes:
> -----Original Message----- > From: [email protected] [mailto:[email protected]] On Behalf Of Mark Sims > Sent: Monday, January 25, 2010 8:53 AM > To: [email protected] > Subject: [time-nuts] DMTD Question > > > > Your board costs are WAY out of line... Are the boards 2 layer or 4 layer? > > You can get 2000 square inches of 2 layer boards for 12 cents/sq in + $120 setup. 4 layers are around > 20 cents/sq in + $320 setup. See mylydia.com > > I would layout the two boards side by side and connected like they would normally be used. If you > don't want to use the counter, saw it off. This would save two setup charges. So for 2 layer your > cost is under $4.50 a set and under $10 for four layers. 2000 sq inches gives over 80 sets of boards. > Does mylydia cost include sawing the 80 sets out of the 2000 square inches? (their website doesn't say) I think the cost that was previously cited includes all the parts on the board. And might include a variety of manufacturing incidentals that all add up, too. Some board houses automatically do the post mfr continuity tests, for instance. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
