The +12VDC supply (internal to the sealed oscillator) supplies both the oven
and the oscillator circuits. I think you'll find that internally this +12VDC
goes to the heater circuit as well as through a regulator to the oscillator
which is running on something like +7VDC. This is speculation at this point but
a number of similar type oscillators I've checked are set up this way and even
have a temperature compensated regulated reference voltage out of about +7VDC
to feed a pot or EFC circuit. For instance the HP 10811 has an internal +5.7VDC
regulated supply for the oscillator circuit
One crude way to check is to take a removed 10Mhz oscillator Trimble oscillator
and power it from a bench supply at +12 and let it stabilize. Then reduce the
supply voltage slowly and see where the output level and/or frequency start to
change. If you see no change until you've reduced the voltage a few volts then
the oscillator has an
internal regulator for the oscillator circuit.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
