Thank you for the replies and help. Regards On Sat, May 1, 2010 at 6:20 AM, <[email protected]> wrote:
> > PS > > The antenna schematics and photos are on TVB's site as Dan suggested.... > > _http://www.leapsecond.com/museum/10509a/_ > (http://www.leapsecond.com/museum/10509a/) > > These are much better quality than those in the HP manual so well worth > getting both. > > regards > > Nigel > GM8PZR > > In a message dated 01/05/2010 11:11:25 GMT Daylight Time, > [email protected] > writes: > > Paul, to get these to work, you will need the loop antenna. This has, > in the early versions at least, a Nuvistor amplifier in it with a > crystal filter built in to it. I think there was a later version that > had transistors. I have seen the schematic somewhere, have you tried > TvB's site? > > Hi Dan and Paul > > The ops and service manual is available from the Agilent site........ > > _http://cp.literature.agilent.com/litweb/pdf/00117-9029.pdf_ > (http://cp.literature.agilent.com/litweb/pdf/00117-9029.pdf) > > Although not the best pdf manual ever it does contain the schematics, > including both antennas, and should be usable. > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
