I'm not sure of the required power spec, but 28V may be too low. These were
meant to run off a telco power bus (nominal 48V).
I run mine at 40V (from a Tek PS503A mounted in a TM501 mainframe, unit
connected across the + and - supply terminals, outputs set to +/- 20V). It
won't run at 28V.
----------------
Input voltage to the poor performing unit is about 28VDC.
_________________________________________________________________
The New Busy is not the old busy. Search, chat and e-mail from your inbox.
http://www.windowslive.com/campaign/thenewbusy?ocid=PID28326::T:WLMTAGL:ON:WL:en-US:WM_HMP:042010_3
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
