In a message dated 10/06/2010 23:34:05 GMT Daylight Time, [email protected] writes:
I'm not sure of the required power spec, but 28V may be too low. These were meant to run off a telco power bus (nominal 48V). I run mine at 40V (from a Tek PS503A mounted in a TM501 mainframe, unit connected across the + and - supply terminals, outputs set to +/- 20V). It won't run at 28V. ----------------- One needs to be careful as there may be different versions, checking is certainly to be recommended but this comment comes from versions 3, 4, and 5, of the Thunderbolt manual..... The ThunderBolt comes with a 24V power supply regulator. A locally supplied +24VDC is required. Power consumption is 15 watts cold and 10 watts steady state. The connector is an AMP mate-n-loc (AMP part number 643228-1). The AMP mate-n-loc mating connectors are listed in the table below. An AMP hand tool (PN 90300-2) may be required...... regards Nigel GM8PZR _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
