Hi As far as I know all the parts are correct except the 74175. It is the soic version.
Bob On Aug 6, 2010, at 7:16 PM, Steve Rooke <[email protected]> wrote: > Bob, > > Thanks for that, this Mouser project has all available parts. Do you > know if the pots, trimmers, etc. are ones as suggested for the correct > orientation, pin spacing, etc. as i believe there was some discussion > regarding this in among the many postings on this topic? > > Steve > > On 07/08/2010, Bob Camp <[email protected]> wrote: >> Hi >> >> I believe the project at: >> >> http://www.mouser.com/ProjectManager/ProjectDetail.aspx?AccessID=8736DCEE10 >> >> is up to date in (no un-orderable parts). >> >> Bob >> >> -----Original Message----- >> From: [email protected] [mailto:[email protected]] On >> Behalf Of Didier Juges >> Sent: Friday, August 06, 2010 8:36 AM >> To: 'Discussion of precise time and frequency measurement' >> Subject: Re: [time-nuts] What's the latest correct PICTIC II Mouser project? >> >> >> I have not seen an answer to that question (for people in the US) ? >> >> I am waiting for the PWB, which I believe I paid for, and I am planning to >> buy or make (have not looked into that yet) a PIC programmer, since it looks >> like I may get some mileage out of that anyhow. >> >> No rush, but there is no good reason to delay either at that point. >> >> Thanks >> >> Didier >> >> >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> >> >> >> >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> > > > -- > Steve Rooke - ZL3TUV & G8KVD > The only reason for time is so that everything doesn't happen at once. > - Einstein > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
