Well crazy as it sounds if you are at 100 KC you might just want 1 loran tower in a chain or even fewer. You only need 1 station not 3. Timing rcvrs worked on one signal.
On Tue, Oct 5, 2010 at 4:46 PM, <[email protected]> wrote: > Not necessarily, on 3 phase systems, you would have to be creative to get > below .9 > > You can easily get to .95 with a simple multipulse rectification. Beyond > that, other than regulatory compliance, you do not gain much efficiency. > > I can't imagine these systems running on anything other than 3 phase power. > > Didier > > Sent from my Verizon Wireless BlackBerry > > -----Original Message----- > From: "J. Forster" <[email protected]> > Sender: [email protected] > Date: Tue, 5 Oct 2010 13:37:21 > To: Discussion of precise time and frequency measurement< > [email protected]> > Reply-To: [email protected], Discussion of precise time and frequency > measurement > <[email protected]> > Subject: Re: [time-nuts] 60 KHz Receiver > > And the Power Factor sucks, so there is a lot less real power being used. > > -John > > ============= > > > Ok, but that is no megawatt! > > > > Also, most of the transmitters were doing multi duty, handling > > several chains simultaneously. That would up the average power > > proportionately. > > > > -Chuck Harris > > > > Poul-Henning Kamp wrote: > >> In message<[email protected]>, Chuck Harris writes: > >>> It is a pulse transmitter. It makes short bursts of 10 or 12 pulses, > >>> and then waits one GRI, and then does it again. I would think the > >>> actual continuous power draw is around 10Kw. > >> > >> http://phk.freebsd.dk/photos/L9007M/dscf0458.jpg.html > >> > >> About 50kW for Ei�i (400kW, 9007M) > >> > >> > >> > >> > >>_______________________________________________ > >> time-nuts mailing list -- [email protected] > >> To unsubscribe, go to > >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > >> and follow the instructions there. > > > >_______________________________________________ > > time-nuts mailing list -- [email protected] > > To unsubscribe, go to > > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > and follow the instructions there. > > > > > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
