Hi For the sake of the poll, anything over 50% confidence is good enough. I'll put you down as yes to all the questions.
Bob -----Original Message----- From: time-nuts-boun...@febo.com [mailto:time-nuts-boun...@febo.com] On Behalf Of michael taylor Sent: Friday, March 25, 2011 2:06 PM To: Discussion of precise time and frequency measurement Subject: Re: [time-nuts] Parts Selection On Fri, Mar 25, 2011 at 1:07 PM, Bob Camp <li...@rtty.us> wrote: > How many people are willing to solder up a project with multiple 0.5mm > spacing >=144 pin package IC's on it? The example was a LQFP 144-pins. Done it before - no, but I have worked with SMT such as 18-pins SOIC (1.27 mm) and 24 pin SSOP (0.65mm), so nearly but fewer pins Done it in the basement / last 2 years - SMT - yes, 0.5mm pitch - no Set up to do it in the basement - yes, but not set up well, lack ideal magnification Would I buy one - most likely, cost/timing dependent Would actually do it in a reasonable amount of time - 50-80% _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.