The circuit board near the 9 pin connector has a number of pads which appear to be option jumper sites. If so it would be nice to know what they do.... just think of the possibilities..
On 01/18/2012 04:44 AM, Bill Riches wrote:
it does nothing - not connected - you might look at the 5680 archives - this and a bunch of other info is listed ad nauseum about the 5680. 73, Bill, WA2DVU Cape May, NJ -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Robert Benward Sent: Tuesday, January 17, 2012 10:01 PM To: Discussion of precise time and frequency measurement Subject: [time-nuts] FE-5680A adjustment screw? Hi all, Anyone know what the little adjustment hole is on the side of the FE-5680A? Is this a frequency adjustment? I tried adjusting it but nothing happened. Was the adjustment range too small to see a change on a counter? _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
-- Chuck Forsberg WA7KGX N2469R [email protected] www.omen.com Developer of Industrial ZMODEM(Tm) for Embedded Applications Omen Technology Inc "The High Reliability Software" 10255 NW Old Cornelius Pass Portland OR 97231 503-614-0430 _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
