I am sure some has covered this already, but does anyone know where I can
get software or a command set to tweak the unit?
Thanks,
Bob
----- Original Message -----
From: "Chris Albertson" <[email protected]>
To: "Discussion of precise time and frequency measurement"
<[email protected]>
Sent: Wednesday, January 18, 2012 1:34 AM
Subject: Re: [time-nuts] FE-5680A adjustment screw?
On Tue, Jan 17, 2012 at 7:00 PM, Robert Benward <[email protected]>
wrote:
Hi all,
Anyone know what the little adjustment hole is on the side of the
FE-5680A? Is this a frequency adjustment? I tried adjusting it but nothing
happened. Was the adjustment range too small to see a change on a counter?
In the current batch of $40 units there is a screw yu can turn but it
is not connected to anything. So it is useless. You have to do the
adjustment using RS232 commands
Sme people have modified the fe5680 to make it work but as delivers
you need a computer or a small uP to adjust them.
Chris Albertson
Redondo Beach, California
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
