Hello, I have two units that don't produce any output and the lock pin floats around +2.3 volts continuously. The +15v load starts at about 1.8A and drops down to about 0.7A on both units, but I never get a +5V or 0V on the lock or a 10MHz out signal. (I'm not using an LED on the lock pin, just a high-impedance DVM.)
I'm relatively confident in my connection setup, since I do have one unit that works "as advertised". In fact, one of the bad units was a replacement from nichegeek, received about three weeks after the original first order of two units (from Amazon.com instead of China). Sorry if this is covered somewhere, but I couldn't find my symptoms on the list... any thoughts are appreciated. Thanks, Dave _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
