Oh yes the send button has a way of getting you to organize your thought process. Glad to hear bad wire though no idea how that actually happens. Regards Paul.
On Tue, Feb 28, 2012 at 12:14 PM, Bob Camp <[email protected]> wrote: > Hi > > It's amazing how often the key element in any troubleshooting procedure is > - > stop, put everything down, take a deep breath, get a cup of coffee, think > about it for a while. I've seen people go for weeks without executing this > very important step. > > Bob > > -----Original Message----- > From: [email protected] [mailto:[email protected]] On > Behalf Of Dave hartzell > Sent: Tuesday, February 28, 2012 12:43 AM > To: Discussion of precise time and frequency measurement > Subject: Re: [time-nuts] 2 out of 3 bad 5680As? > > Bill, > > Yes, +5v.... but I was doing it incorrectly (bad hookup wire on both > units). I haven't checked the second "bad" unit, but it will probably > work now too. > > Sometimes I have to hit the "send" button before I find my errors. > > Thanks for the thoughts, > > Dave > > On Mon, Feb 27, 2012 at 10:31 PM, WB6BNQ <[email protected]> wrote: > > Hi Dave, > > > > A silly question, although you did not indicate, you are supplying a > separate 5 > > volts to the unit are you not ? > > > > Bill....WB6BNQ > > > > > > Dave hartzell wrote: > > > >> Hello, > >> > >> I have two units that don't produce any output and the lock pin floats > >> around +2.3 volts continuously. The +15v load starts at about 1.8A > >> and drops down to about 0.7A on both units, but I never get a +5V or > >> 0V on the lock or a 10MHz out signal. (I'm not using an LED on the > >> lock pin, just a high-impedance DVM.) > >> > >> I'm relatively confident in my connection setup, since I do have one > >> unit that works "as advertised". In fact, one of the bad units was a > >> replacement from nichegeek, received about three weeks after the > >> original first order of two units (from Amazon.com instead of China). > >> > >> Sorry if this is covered somewhere, but I couldn't find my symptoms on > >> the list... any thoughts are appreciated. > >> > >> Thanks, > >> > >> Dave > >> > >> _______________________________________________ > >> time-nuts mailing list -- [email protected] > >> To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > >> and follow the instructions there. > > > > > > _______________________________________________ > > time-nuts mailing list -- [email protected] > > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
