Re: [time-nuts] Trimble Resolution SMT - good/bad/indifferent?

[Mark Sims]

I got a couple of these in and cannot get them to talk.   There are two pins on 
the connector that are labeled reserved and no-connect.  The no-conect pin has 
a trace going to (at least) a cap.  Perhaps there is an enable pin?  Has 
anybody got these to work?                                        
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.