What's bad with the Motorola binary protocol? In my opinion it is superior to the NMEA one...
On Thu, May 10, 2012 at 9:55 PM, <[email protected]> wrote: > Ok, > > I figured out that the unit fluke.l sells is running firmware to emulate > the Motrola M12+ receiver or similar. So WinOncore 12 does work, and I can > get the following receiver ID: > > COPYRIGHT 2008 Trimble Navigation Ltd. > SFTW P/N # 0000 > SOFTWARE VER # 0.03.0 > SOFTWARE REV # 00 > SOFTWARE DATE 04/27/2009 > MODEL # 3011 > HDWR P/N # 0000 > SERIAL # 20393136 > MANUFACTUR DATE 06/05/2009 > OPTIONS LIST 0000 > > Does anyone know what the command is to configure this for NMEA or TSIP? > > Thanks, > Said > > > In a message dated 5/10/2012 12:15:56 Pacific Daylight Time, > [email protected] writes: > > Hi Holrum, > > how do you re-configure the SMT unit? Using Trimble GPS studio? > > Thanks, > Said > > > In a message dated 5/9/2012 15:17:21 Pacific Daylight Time, > [email protected] writes: > > I have it running now. It turns out that the units from fluke.l come > shipped with TEP format messages enabled (it outputs @@Cf on power up). > You > have to re-configure them for TSIP protocol and save the configuration > back > to the unit. Hope to have Lady Heather taking to it. It does come up > with > several of the messages working. Sat info is not one of them. > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
