Ok, I figured out that the unit fluke.l sells is running firmware to emulate the Motrola M12+ receiver or similar. So WinOncore 12 does work, and I can get the following receiver ID: COPYRIGHT 2008 Trimble Navigation Ltd. SFTW P/N # 0000 SOFTWARE VER # 0.03.0 SOFTWARE REV # 00 SOFTWARE DATE 04/27/2009 MODEL # 3011 HDWR P/N # 0000 SERIAL # 20393136 MANUFACTUR DATE 06/05/2009 OPTIONS LIST 0000 Does anyone know what the command is to configure this for NMEA or TSIP? Thanks, Said In a message dated 5/10/2012 12:15:56 Pacific Daylight Time, [email protected] writes: Hi Holrum,
how do you re-configure the SMT unit? Using Trimble GPS studio? Thanks, Said In a message dated 5/9/2012 15:17:21 Pacific Daylight Time, [email protected] writes: I have it running now. It turns out that the units from fluke.l come shipped with TEP format messages enabled (it outputs @@Cf on power up). You have to re-configure them for TSIP protocol and save the configuration back to the unit. Hope to have Lady Heather taking to it. It does come up with several of the messages working. Sat info is not one of them. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
