On 01/28/2013 01:01 AM, Ed Breya wrote:
If you meant to say the frequency starts out too high when the oven is cold, then I think it's AT cut.
OK. I looked at the previous posts and it was not very clear from them, and I was too lazy/busy to heat up an idel AT OCXO. I just felt the +41.4 ppm deviation was a little low for an AT cut.
Meanwhile, out of 22 LPROs tested, only 3 has BITE error, so 19 locks up. Out of 4 cesiums tested, 3 locks up and one fails. Trimming needed on all.
Cheers, Magnus _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
