Hi It could also be an AT, IT or FC cut. A lot depends on just how hot the oven is running. Best bet is indeed AT.
Bob On Jan 27, 2013, at 7:40 PM, Magnus Danielson <mag...@rubidium.dyndns.org> wrote: > On 01/28/2013 01:01 AM, Ed Breya wrote: >> If you meant to say the frequency starts out too high when the oven is >> cold, then I think it's AT cut. > > OK. I looked at the previous posts and it was not very clear from them, and I > was too lazy/busy to heat up an idel AT OCXO. I just felt the +41.4 ppm > deviation was a little low for an AT cut. > > Meanwhile, out of 22 LPROs tested, only 3 has BITE error, so 19 locks up. Out > of 4 cesiums tested, 3 locks up and one fails. Trimming needed on all. > > Cheers, > Magnus > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
