Yes, this switch matrix seems intended for video signals, so 75 ohms is
the expected standard. I doubt that would be much of a problem for 50
ohm timing signals. Some of us shall see soon. BNCs may be 75 ohm
versions too, but probably not a big issue.
On 2/11/2013 6:20 PM, J. L. Trantham wrote:
Looks like 75 ohms if I understand the manual correctly.
Joe
-----Original Message-----
From: [email protected] [mailto:[email protected]] On
Behalf Of Don Latham
Sent: Monday, February 11, 2013 8:00 PM
To: time nuts
Subject: [time-nuts] altinex switches
I bought a couple of
180986059633
switches. The manual is at:
http://pdf.textfiles.com/manuals/STARINMANUALS/Altinex/Manual/Archive/Home%2
0Run%20(HR)%20Series.pdf
You get 8 inputs switchable to 12 outputs IN ANY COMBO. meaning it can be a
12 output distribution amp. isolation amps all round, and either
200 or 300 MHz bandwidth. dc coupled, have a look. There are some left.
Don
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
