You cannot enter minutes and seconds of degrees greater than 59. The correct coords: -33... is 33 deg 45 minutes and 49.3128 seconds (S 33 45' 49.3128") 151... is 151 deg 5' 31.596"
On Fri, Jul 12, 2013 at 7:51 PM, Mark C. Stephens <[email protected]> wrote: > When I try to enter my antenna location as per surveyor: > -33.763698 > 151.092111 > > With this scpi command: > :GPS:POS S,+33,+79,3.69800E+001,E,+151,+9,+2.11100E+001,+9.45600E+001 > > For some reason, the Z3816A displays this: > LAT S 33:59:36.980 > LON E 151:09:21.110 > > Which is correct except the south should say 33:79:36.980. > > I can enter lower values that 59 for parameter 3 and it displays correct. > Can't seem to find a manual for these chaps either. > > Shooting off the subject, Just had one arrive with a loose OCXO. > Yes loose, the solder joint on the OCXO had broken away from the PCB. > The intermittent contact was causing all sorts of chaos. > Most noticeably, the red ALARM LED came on, but none of the scpi commands > could tell me why. > Health monitor reported [ OK ] <shrug> > > Anyway, Any idea how I can enter the correct co-ordinates? > > > --marki > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
