Hello Samuel,
Well, I just got done designing and building the very same thing. If I
recall correctly it is the same as the HC4046 which is 4 MHz. The 9046
VCO will only go up to 20 MHz absolute maximum. So you will need an
external oscillator and dividers.
Bill....WB6BNQ
sg sg wrote:
Hi,
I'm about to implement a PLL for a 24.576 MHz VCXO using the phase-frequency
detector (PC2) of the NXP 74HCT9046A. From the datasheet
(www.nxp.com/documents/data_sheet/74HCT9046A.pdf) it is not clear to me what
the maximum operating frequency for this phase detector is--from the enable and
disable times (page 20 and figure 19) I presume 24.576 MHz is too much.
So I probably need to add dividers at the inputs. Can someone advise me on the
choice of division ratio?
Thanks for your time,
Samuel
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
