Ah, I had wondered about that but was probably being a bit selfish as I only have the GPS based units:-) Given the similarity, I would assume where we've got to on these wouldn't be a bad starting point, and at least identifying the 1PPS input on the interface connector should be straightforward enough. Regards Nigel GM8PZR In a message dated 02/11/2014 19:41:07 GMT Standard Time, [email protected] writes:
Hi No, once we get the GPS end worked out, we need to do the same thing for the non-GPS end. If we can fake it into working with just a PPS, it’s the perfect thing to use to attach an OCXO to a newer GPS (like the Jackson Labs part …). Bob > On Nov 2, 2014, at 2:15 PM, GandalfG8--- via time-nuts <[email protected]> wrote: > > Hi Gotz > > That's great stuff, thank you, I'll try that later. > > At this rate we'll soon be finding ways of doing this without any wiring > whatsoever, perhaps we could start with just standing it upside down in a > dark corner on the night of the full moon:-) > > Regards > > Nigel > GM8PZR > > > In a message dated 02/11/2014 17:58:12 GMT Standard Time, [email protected] > writes: > > > > Am 02.11.2014 15:08, : >> Ooh err, whoops, and oh dear !! >> >> Arthur, I've only just had a chance to look at your latest photos, and >> unless I've really got my wires crossed, if you'll pardon the > expression:-), >> your links on J5 are not shown on pins 2, 10, 12, and 15, but on pins > 4, 6, >> 11, and 13. >> >> As far as I'm aware the numbering from the front of that connector as > shown >> starts in the top right hand corner and every row is numbered right to >> left. >> That's certainly how mine are numbered anyway, and I wired them >> accordingly, and it worked, so where the heck does that leave us now?:-) >> > -------------------------- > thanks Nigel for detecting this glitch. I removed all jumpers now and > tested some reasonable new/old combinations resulting in very simple > scheme: > it seems to be sufficient to connect pin2 and pin3 to pin8 (ground). > Numbering as provided by Nigel and markings on my 15 pin-plug. > > Götz > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
