Hi It *might* plug in the GPS version. It also might report more sat’s than the firmware expects and everything would quickly die. That’s certainly the case with retrofitting some of the other early GPSDO’s. I think I’d rather play with faking out non-GPS version.
Bob > On Nov 2, 2014, at 2:56 PM, Bob Stewart <[email protected]> wrote: > > Hi Bob, > There's also the option of the SSR-6Tr and adapter board from Synergy GPS. > It should plug right in. You'd need the Oncore compatible version. Kinda > pricey though. > > Bob > From: Bob Camp <[email protected]> > To: [email protected]; Discussion of precise time and frequency measurement > <[email protected]> > Sent: Sunday, November 2, 2014 1:41 PM > Subject: Re: [time-nuts] Lucent KS-24361, HP/Symmetricom Z3809A, Z3810A, > Z3811A, Z3812... > > Hi > > No, once we get the GPS end worked out, we need to do the same thing for the > non-GPS end. If we can fake it into working with just a PPS, it’s the perfect > thing to use to attach an OCXO to a newer GPS (like the Jackson Labs part …). > > Bob > >> On Nov 2, 2014, at 2:15 PM, GandalfG8--- via time-nuts <[email protected]> >> wrote: >> >> Hi Gotz >> >> That's great stuff, thank you, I'll try that later. >> >> At this rate we'll soon be finding ways of doing this without any wiring >> whatsoever, perhaps we could start with just standing it upside down in a >> dark corner on the night of the full moon:-) >> >> Regards >> >> Nigel >> GM8PZR >> >> >> In a message dated 02/11/2014 17:58:12 GMT Standard Time, [email protected] >> writes: >> >> >> >> Am 02.11.2014 15:08, : >>> Ooh err, whoops, and oh dear !! >>> >>> Arthur, I've only just had a chance to look at your latest photos, and >>> unless I've really got my wires crossed, if you'll pardon the >> expression:-), >>> your links on J5 are not shown on pins 2, 10, 12, and 15, but on pins >> 4, 6, >>> 11, and 13. >>> >>> As far as I'm aware the numbering from the front of that connector as >> shown >>> starts in the top right hand corner and every row is numbered right to >>> left. >>> That's certainly how mine are numbered anyway, and I wired them >>> accordingly, and it worked, so where the heck does that leave us now?:-) >>> >> -------------------------- >> thanks Nigel for detecting this glitch. I removed all jumpers now and >> tested some reasonable new/old combinations resulting in very simple >> scheme: >> it seems to be sufficient to connect pin2 and pin3 to pin8 (ground). >> Numbering as provided by Nigel and markings on my 15 pin-plug. >> >> Götz >> >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
