Turns out the Interface J5 perfectly accepts .1 inch spaced pins. You may have these laying around. I simply snipped off 2 sets of 3 pins. Placing them in J5 1-3 and J5 6-8. The additional pins make it very stable. Then solder ground from pin 8 to 3 and 470 ohm chip resistor from 3 to 2. Thats it. Very stable with parts from the drawer.
Regards Paul WB8TSL _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
