Hi I toss my DC load resistors on an un-used port on the splitter. That way they really don’ mess anything up. I don’t bother with a coil, but I also don’t bother with short leads.
Bob > On Nov 9, 2014, at 8:33 PM, paul swed <[email protected]> wrote: > > Turns out the Interface J5 perfectly accepts .1 inch spaced pins. > You may have these laying around. I simply snipped off 2 sets of 3 pins. > Placing them in J5 1-3 and J5 6-8. The additional pins make it very stable. > Then solder ground from pin 8 to 3 and 470 ohm chip resistor from 3 to 2. > Thats it. Very stable with parts from the drawer. > > Regards > Paul > WB8TSL > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
