Thank you all for the answer to my query.
cheers, Graham ve3gtc
On 2014-11-21 21:17, Bob Camp wrote:
Hi
We’ve been around this one before. The KS boxes are powered by a switcher brick
inside the box. There’s not a lot of reason go super crazy on the DC input.
It’s fully isolated from the case ground. Even leakage / stray grounds should
not be an issue in this situation. I would not run it off of raw un-filtered
rectifier output. Anything that’s at least got a filter capacitor in it should
do fine.
Bob
On Nov 21, 2014, at 3:19 PM, Neil Schroeder <[email protected]> wrote:
I drive my prs10 with a parallel pair of ldos balanced by an op amp. I'll
draw it out and post it if you like.
On Friday, November 21, 2014, Azelio Boriani <[email protected]>
wrote:
At most you need 2.4A (when the two OCXOs are heating up): a 2.5A
supply is needed.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
