SO, I just connected my third LTE-Lite unit.
By the time the software drivers were installed, and I selected U-center
to the new COMM port, it had a fix. Even with the survey LED still
blinking.
I looked at the GoogleEarth view, and the fix is within six feet of
where the antenna really is. IMPRESSIVE.
BTW, the 10 MHz unit I ran for a couple of days showed a fix on
GoogleEarth within less than a foot of the antenna location.
Most impressive.
Jim
On 11/28/2014 4:23 PM, Jim Sanford wrote:
All:
After running my 20 MHz LTE-Lite for a week or so, I shut it down and
connected one of the 10 MHz units.
The LEDs appear to be responding (survey still in progress) as per the
quick start guide.
Windows installed a new comm port and driver. (COMM6, with FTDI
driver) The COMM5 port which was the 20 MHz unit is gone.
U-center has selected COMM6 and is autobaud at 38000, but is showing
my nothing except blank screens and a red NO FIX. Have I missed
something? Or will it not report anything until a lock is achieved??
Thanks,
Jim
[email protected]
---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
---
This email has been checked for viruses by Avast antivirus software.
http://www.avast.com
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
