David it always does a survey. Though even while doing that the frequency output is fine after its had a bit to stabilize. I wanted to bring the survey lamp out to a front panel LED however that appeared to be more work and risk then the value. The documentation says that from time to time it will do a re-survey. Frankly my units racked and stacked with dividers filters and line drivers for various frequencies I am using and its running very very smoothly.
By the way at a huge power consumption of 1-3 watts. The power mete doesn't read well at this level. Regards Paul WB8TSL On Thu, Dec 4, 2014 at 11:07 AM, David J Taylor < david-tay...@blueyonder.co.uk> wrote: > With the LTE-Lite, are the survey results held in non-volatile memory, or > does it need to do a survey each time it is switched on? This is a fixed > location. > > The survey light is still on after a number of hours of operation (but it > may have gone off in the meanwhile), and the GPS light sometimes flashes > and sometimes not. The signals I'm seeing at the moment are: 24 30 26 18 > 32 27 21 18 and 19 in the "signal quality" indicator of Visual GPS. This > with the puck on the top storey of a two storey building, but indoors. > Other GPS pucks work fine in the same location. The PPS output appears to > be correct, and there is 20 MHz from the 20 MHz port, but nothing from the > Clock Out port on this 10 MHz unit. > > The unit is as-received, with the exception of switching to NMEA sentences. > > Thanks, > David > -- > SatSignal Software - Quality software written to your requirements > Web: http://www.satsignal.eu > Email: david-tay...@blueyonder.co.uk > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to https://www.febo.com/cgi-bin/ > mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.