On 1 Dec 2014 03:35, "paul swed" <[email protected]> wrote: > > OK so it was not as hard as I thought getting all of teh screws out. The > harder part is getting the actual board to slip out of the back. > After getting to the bottom I found a locked 10 Mhz signal on U206 pin 1 > somewhat of a sine wave
Why do you need to do this? The picture I see on eBay shows an SMA connector with "10 MHz TP" on it. I assumed that was a 10 MHz output, but I assume that there's a good reason you are doing this. Dave _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
