Bob I agree with your comments. For the test gear on the bench this will be very fine. Regards Paul WB8TSL
On Wed, Dec 3, 2014 at 7:40 PM, Bob Camp <[email protected]> wrote: > Hi > > Be careful when you do this. > > A signal with harmonics 20 db down and sub-harmonics 30 db down will make > a fine reference input for a counter / signal generator / spectrum analyzer. > > A signal with a 1 second ADEV of 5x10^-10 will look absolutely perfect on > any spectrum analyzer ever made. It will not be a good a reference for an > instrument as a source at 5x10^-12. > > Close in phase noise / ADEV is what you need to set up to check. A > relative test is fine ( divide 10 by 2 and compare to 5), but that’s what > you need to check > > Bob > > > On Dec 3, 2014, at 6:04 PM, paul swed <[email protected]> wrote: > > > > Have successfully tapped into the clean 10 MHz of the the Lucent and > using > > a EL2020 50 Mhz current opamp have a very nice 10 Mhz sine wave out. Any > > spurs are down at least 43 db. Close in at 4Khz total span or 500 Hz/div > I > > don't see anything down to at least 65 db. Thats the best detail the HP > > 8568B will allow. > > > > To get the signal out of the Lucent I sliced the 15 Mhz trace and > injected > > the 10 Mhz into the SMA output connector. > > > > I am sure there are many other amplifiers and methods that could be used > > but this ones working well and can drive some real coax lengths. > > > > Now the really hard part. Mounting it and the power supply into a rack > > panel. > > Regards > > Paul > > WB8TSL > > _______________________________________________ > > time-nuts mailing list -- [email protected] > > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
