Paul - could you elaborate on where you made the connections? A few photos perhaps?
Nice work, Anthony -----Original Message----- > On Dec 3, 2014, at 6:04 PM, paul swed <[email protected]> wrote: > > Have successfully tapped into the clean 10 MHz of the the Lucent and > using a EL2020 50 Mhz current opamp have a very nice 10 Mhz sine wave > out. Any spurs are down at least 43 db. Close in at 4Khz total span or > 500 Hz/div I don't see anything down to at least 65 db. Thats the best > detail the HP 8568B will allow. > > To get the signal out of the Lucent I sliced the 15 Mhz trace and > injected the 10 Mhz into the SMA output connector. > > I am sure there are many other amplifiers and methods that could be > used but this ones working well and can drive some real coax lengths. > > Now the really hard part. Mounting it and the power supply into a rack > panel. > Regards > Paul > WB8TSL > _______________________________________________ > time-nuts mailing list -- [email protected] To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
