I may have missed this info in a previous post, but I am interested in tapping off the 5 MHz signal. I have my REF-1 apart, but don't have it powered. I will buffer the signal, and suspect the 5 MHz is available right around Q205, but it might be up around Q204 or Q203. Could someone advise me as to exactly where to pick off a nice 5 MHz sine wave? Thanks, -Doug R. -----Original Message----- From: time-nuts [mailto:[email protected]] On Behalf Of paul swed Sent: Wednesday, December 03, 2014 3:05 PM To: Time-nuts Subject: [time-nuts] Lucent KS-24361 10 Mhz out success.
Have successfully tapped into the clean 10 MHz of the the Lucent and using a EL2020 50 Mhz current opamp have a very nice 10 Mhz sine wave out. Any spurs are down at least 43 db. Close in at 4Khz total span or 500 Hz/div I don't see anything down to at least 65 db. Thats the best detail the HP 8568B will allow. To get the signal out of the Lucent I sliced the 15 Mhz trace and injected the 10 Mhz into the SMA output connector. I am sure there are many other amplifiers and methods that could be used but this ones working well and can drive some real coax lengths. Now the really hard part. Mounting it and the power supply into a rack panel. Regards Paul WB8TSL _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
