I have a pix of the point to tap. Its on the bottom of the board. Not sure I can skinny it down to fit Time Nuts has to be sub 100K. I will tinker tomorrow night and see if I can get it down. Regards
On Wed, Dec 3, 2014 at 10:40 PM, paul swed <paulsw...@gmail.com> wrote: > J8 its unpopulated right next to the oven. > Regards > Paul > WB8TSL > > On Wed, Dec 3, 2014 at 7:36 PM, Doug Ronald <d...@dougronald.com> wrote: > >> I may have missed this info in a previous post, but I am interested in >> tapping off the 5 MHz signal. I have my REF-1 apart, but don't have it >> powered. I will buffer the signal, and suspect the 5 MHz is available right >> around Q205, but it might be up around Q204 or Q203. Could someone advise >> me as to exactly where to pick off a nice 5 MHz sine wave? >> Thanks, >> -Doug R. >> -----Original Message----- >> From: time-nuts [mailto:time-nuts-boun...@febo.com] On Behalf Of paul >> swed >> Sent: Wednesday, December 03, 2014 3:05 PM >> To: Time-nuts >> Subject: [time-nuts] Lucent KS-24361 10 Mhz out success. >> >> Have successfully tapped into the clean 10 MHz of the the Lucent and >> using a EL2020 50 Mhz current opamp have a very nice 10 Mhz sine wave out. >> Any spurs are down at least 43 db. Close in at 4Khz total span or 500 >> Hz/div I don't see anything down to at least 65 db. Thats the best detail >> the HP 8568B will allow. >> >> To get the signal out of the Lucent I sliced the 15 Mhz trace and >> injected the 10 Mhz into the SMA output connector. >> >> I am sure there are many other amplifiers and methods that could be used >> but this ones working well and can drive some real coax lengths. >> >> Now the really hard part. Mounting it and the power supply into a rack >> panel. >> Regards >> Paul >> WB8TSL >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> >> _______________________________________________ >> time-nuts mailing list -- time-nuts@febo.com >> To unsubscribe, go to >> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. >> > > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.