All you need is a 10 MHz low pass filter.

How far down do you need the harmonics/spurious to be?

If 40 dB suppression of the 2nd and 3rd harmonics is adequate,
(you can't see the distortion with the eye on an oscilloscope)
you can make your own for about $2 in parts, not including a PC board or
housing.

Feel free to copy the low pass filter (L1, C9, C10) from here:
http://openhpsdr.org/wiki/index.php?title=EXCALIBUR

Or for about $35, you could get the same performance from an inline BNC
filter from Minicircuits.

http://www.minicircuits.com/pdfs/BLP-10.7+.pdf

If you need more harmonic suppression, buy two and put them in series.

--- Graham

==



--- Graham

==



On Thu, Jul 16, 2015 at 12:49 PM, skipp Isaham via time-nuts <
time-nuts@febo.com> wrote:

> re: 10MHz Square to Sine Wave Conversion
>
> The GPSDO I recently acquired outputs a 10 MHz square wave. I'd like
> to convert it to a sine wave and I am looking for suggestions and info re
> any reasonable pre-made circuits and/or boards. No sense reinventing the
> wheel if I can avoid it.
>
> Otherwise I will start from scratch and make a new wheel....
>
> Thank you in advance for your replies.
>
> Regards,
>
> skipp
>
> skipp025 at yahoo dot com
>
> _______________________________________________
> time-nuts mailing list -- time-nuts@febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
_______________________________________________
time-nuts mailing list -- time-nuts@febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.

Reply via email to