How good does the sine wave need to be? The usual method is to use a low-pass filter A CLC "pi" filter works.
On Thu, Jul 16, 2015 at 10:49 AM, skipp Isaham via time-nuts <[email protected]> wrote: > re: 10MHz Square to Sine Wave Conversion > > The GPSDO I recently acquired outputs a 10 MHz square wave. I'd like > to convert it to a sine wave and I am looking for suggestions and info re > any reasonable pre-made circuits and/or boards. No sense reinventing the > wheel if I can avoid it. > > Otherwise I will start from scratch and make a new wheel.... > > Thank you in advance for your replies. > > Regards, > > skipp > > skipp025 at yahoo dot com > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. -- Chris Albertson Redondo Beach, California _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
