Hi Dan,
I would be interested on that document too
Thank you in advance
73
KJ6UHN
Alex
On 8/3/2015 12:40 PM, Dan Kemppainen wrote:
Hi,
If you search the internet, you should come across a design by Warren
S. It's basically the same type of oven controller that is used in the
internal oven for that oscillator.
I did a surface mount version of his design a while back. I've been
running it for quite a while now. IMO it is helping to reduce the
thermal drift of the oscillator.
Bob has pointed out in the past that the outer oven was not intended
to be active all of the time. This is probably true. That said it
seems to help in my setup.
If you are unable to find the documentation, please let me know. I can
try to dig it up when I get home.
Dan
On 8/3/2015 12:00 PM, [email protected] wrote:
Hi
The “external” heater on the Z3801 OCXO is only needed if you are
regularly running below -20C in your environment. Other than
the alarm signal, there is no harm in letting it simply shut off
forever.
Bob
>On Aug 2, 2015, at 8:56 AM,[email protected] wrote:
>
>
>Hi,
>I have seen, but I do not remember where, someone have rebuilt the
external oven controller to complete a stand alone OCXO removed from
an HPZ3801A.
>Can you hep me to find the document?
>
>Luciano
>timeok
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
