Bevor I heat up the big soldering iron to remove the OCXO, I wanted to ask if anybody else experienced this before and if anybody can confirm
that tuning voltage range is indeed 0..6 Volt. If so, replacing the OCXO should cure the problem. Hi Mathias I've not experience your problem with the KS-24361, but I have tested a few of these oscillators stand alone and can confirm that the reference voltage output has always been approximately 6 Volts and they do accept an EFC tuning voltage range of 6 Volts. Other than one faulty unit, on all those I've tested the EFC voltage has been very close to 3 Volts when the oscillator frequency was within a few parts in 10^11 of 5 MHz. For example, looking back at a couple of test results, one was at 2.9725 Volts and another at 3.0970 Volts. Regards Nigel GM8PZR Hey, hows about that, It seems like I might finally have found a way to reply to list messages straight from the archives without receiving them by email:-) _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
