Over the years I've used a number of CATV style 75 ohm patch cords with F connectors, F female to female couplers and F to other connector adaptors to distribute gps signals from my GPS splitter to various receivers. I've never been able to notice any difference in reported signal strength vs using "brand name" 50 ohm coax with N connectors.
That being said I've never looked at the cables on a network analyzer (: Your mileage may vary Sent from my iPhone > On Dec 5, 2015, at 3:23 PM, Bert Kehren via time-nuts <[email protected]> > wrote: > > > Thank you all for the information, worse case I look at 70 feet with two > couplings all in an inaccessible attic. The cable is quality but vintage > 1989. Part of an extensive cable TV wiring. So far nine with two I am not > able > to locate the other end.The way they are installed I am not able yet to use > one of them to pull a new one in. > Twenty years ago I probably would have risked crawling in there. Don't want > to fall 16 feet at age 73. > Bert Kehren Palm City . > > > > In a message dated 12/5/2015 5:11:01 P.M. Eastern Standard Time, > [email protected] writes: > > Bert, > > Extending the RG-6U using N-connectors should not be giving you more > than 0.20 dB, probably less. Considering that you have have 6.12 dB per > 100 feet in RG-6U at 1 GHz (should be about 8 dB @ 1.575 GHz), so it > will be more. Using N-connectors to extend the cable-stretch isn't going > to be a major issue, it may be the cable length that could present an > issue. > > I've been fighting these issues, and used too long cable at hand (RG-58 > is a terrible choice but was lying around at the time). I use LMR-400 > these days, giving me about 5.1 dB per 100 feet. > > If cable and connector damping causes you harm, then consider installing > an additional LNA inline with the antenna. > > Hope it sort itself out for you. > > Cheers, > Magnus > >> On 12/05/2015 09:28 PM, Bert Kehren via time-nuts wrote: >> At my new home the GPS antenna location has turned in to a challenge. > May >> have to splice RG 6U. Has any one done measurements on couplings and the >> loss associated with them. Right now I am considering a female, female >> coupling. Is there a better alternative? >> Thanks Bert Kehren Palm City Fl. >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
