Jim,
I use a HP 6236B triple power supply to drive 2 each T'Bolts. Works fine
after the T'Bolts warm up, with limitations on a cold start up.
But once they warm up all is OK.
Using a common outside puck antenna and a HP RF distribution block I can
run 3 T'Bolts and get essentially the same results.
#1 T'Bolt is on a HP 6235A DC PS and #2 and #3 are on the 6236B. #1 has
been on for years.
I am planning to box up and use a Mean Well SMPS common power supply
that will handle the load current of 3 T'Bolts starting cold.
Adding a few digital panel meters to measure individual load currents
and voltages.
Stan, W1LE Cape Cod
On 9/1/2016 9:44 AM, James Robbins wrote:
Is there a problem running more than one Thunderbolt off of the same linear
supply (assuming the supply can support the current demands) or does each
Thunderbolt require its’ own separate linear supply? Jim Robbins
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
_______________________________________________
time-nuts mailing list -- [email protected]
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
