Mark in your experience with these units, are the Trimble units adjustable in any way with regards to the oscillator such as damping, time constant etc. I had a Symmetricom unit but accidently fried it so could not experiment any further. I could not find any command that would allow any fine tuning of the OCXO. Wonder what the PullinRange means?
UCCM-P> ? *IDN? ALARm:HARDware? ALARm:OPERation? DIAGnostic:OUTPut ON|OFF OUTPut:ACTive:ENABle OUTPut:ACTive:DISable OUTPut:ACTive:HOLDover:DURation:THReshold <seconds> OUTPut:ACTive:HOLDover:DURation:THReshold? OUTPut:INACTive OUTPut:INACTive? OUTPut:STATe? SYNChronization:HOLDover:DURation:STATus:THReshold <seconds> SYSTem:PRESet SYNChronization:TFOMerit? LED:GPSLock? SYNChronization:FFOMerit? GPS:POSition N or S,<deg>,<min>,<sec>,E or W,<deg>,<min>,<sec>,<height> GPS:POSition? GPS:POSition:HOLD:LAST? GPS:REFerence:ADELay <numeric value> GPS:REFerence:ADELay? GPS:SATellite:TRACking:COUNt? GPS:SATellite:TRACking? DIAGnostic:ROSCillator:EFControl:RELative? SYNChronization:TINTerval? DIAGnostic:LOG:READ:ALL? DIAGnostic:LOG:CLEar SYSTem:PON OUTPut:MODE? SYSTem:STATus? SYSTem:COMMunication:SERial1:BAUD 9600|19200|38400|57600 SYSTem:COMMunication:SERial1:BAUD? SYSTem:COMMunication:SERial1:PRESet SYSTem:COMMunication:SERial2:BAUD 9600|19200|38400|57600 SYSTem:COMMunication:SERial2:BAUD? SYSTem:COMMunication:SERial2:PRESet OUTPut:STANby:THReshold <seconds> changeSN SYNChronization:REFerence:ENABLE LINK|GPS SYNChronization:REFerence:DISABLE LINK|GPS SYNChronization:REFerence:ENABLE? STATus POSSTATus TOD EN|DI TIME:STRing? REFerence:TYPE GPS|LINK REFerence:TYPE? PULLINRANGE 0|1|2|...|254|255 PULLINRNAGE? DIAGnostic:LOOP? DIAGnostic:ROSCillator:EFControl:DATA GPS|<value> DIAGnostic:ROSCillator:EFControl:DATA? OUTPut:TP:SELection PP1S|PP2S OUTPut:TP:SELection? GPSystem:SATellite:TRACking:EMANgle <degrees> GPSystem:SATellite:TRACking:EMANgle? DIAGnostic:TCODe:STATus:AMASk DIAGnostic:TCODe:STATus:OMASk DIAGnostic:TCODe:ERRor:AMASk DIAGnostic:TCODe:ERRor:OMASk DIAGnostic:HOLDover:DELay DIAGnostic:HOLDover:DELay? GPS:SATellite:TRACking:IGNore <PRN>, ...,<PRN> GPS:SATellite:TRACking:IGNore? GPS:SATellite:TRACking:INCLude <PRN>, ...,<PRN> GPS:SATellite:TRACking:INCLude? GPS:SATellite:TRACking:<select>:ALL Command Complete UCCM-P > p.s. Looking forward to the latest Lady Heather release. -=Bryan=- ________________________________ From: time-nuts <[email protected]> on behalf of Mark Sims <[email protected]> Sent: October 23, 2016 6:08 PM To: [email protected] Subject: [time-nuts] Has anybody checked this? GPSDO in kit For the money, those are excellent little GPSDOs... providing that it wasn't damaged while being salvaged. I got three different models in from 3 different sources and they all worked well. They are not nearly as tweakable as the Tbolt (nothing is) but they seem to get the job done. Supposedly the Symmetricom units have marginally better phase noise (YMMV), but I prefer the Trimble units for the sole reason that you can save the surveyed position and other settings in EEPROM and then they don't have do a survey each time you power them up. And yes, the next release of Lady Heather works with them. The biggest annoyance is the time code message only comes out every two seconds so the clock displays tick on two second intervals. Lady Heather really want to run on a one-second update interval, so internally I fake the odd seconds so things like the alarm clock mode works properly. I have the code for the next release pretty much completed and am currently (GASP!) writing some (EGAD!) documentation (OH THE HUMANITY!) -------------------- > Only cheap alternative could be this one(already discussed here one year ago): http://www.ebay.com/itm/141734507722?_trksid=p2057872.m2749.l2649 [http://i.ebayimg.com/images/i/141734507722-0-1/s-l1000.jpg]<http://www.ebay.com/itm/141734507722?_trksid=p2057872.m2749.l2649> Used Tested 10MHz Trimble 63090/73090/65256 GPS board OCXO | eBay<http://www.ebay.com/itm/141734507722?_trksid=p2057872.m2749.l2649> www.ebay.com Note : this item is used ,but Good quality. | eBay! Would this allow me to play as the "standard" ThunderBolt using the same software? Any preferred model among 63090/73090/65256 "models"? _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts time-nuts Info Page - American Febo Enterprises<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts> www.febo.com time-nuts is a low volume, high SNR list for the discussion of precise time and frequency measurement and related topics. To see the collection of prior postings to ... and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
