Hi Just going by memory (never a good thing ….); You can make the GPS unit believe that it has a “slave” present *and* that the slave is not working properly. It’s all done with logic levels. In the “slave down” mode, the unit with the GPS puts out the 15 MHz and all the messages. The thing you loose is the (dirty) 10 MHz output from the slave.
Bob > On Nov 14, 2017, at 11:30 AM, Jerry Hancock <[email protected]> wrote: > > Bob, I thought you had to send it code, etc? I have the two units with > cable, etc running upstairs. I want another one for in my office but the > same guy only sells the REF0 and REF1 units separately now without the cable. > I thought about splitting the two and using this other GPS unit I have (it > was one of the TAPR GPS Kits) to send the other one the 1pps. You’re saying > all you need is a plug? I would need two functioning units. > > Regards, > > Jerry > > > Jerry Hancock > [email protected] > (415) 215-3779 > >> On Nov 14, 2017, at 8:13 AM, Bob Camp <[email protected]> wrote: >> >> Hi >> >> If you are going to get out the soldering iron, why simply make up a plug >> to run the GPS unit stand alone? Keep the second unit powered down >> as a set of spare parts….. Yes, it does depend a bit on what you are doing >> with them …. >> >> Bob >> >>> On Nov 13, 2017, at 11:50 PM, Jerry Hancock <[email protected]> wrote: >>> >>> Anyone have a spare cable for the Lucent setup? I guess I can make one >>> with some DB15 connectors but trying to skip the effort. >>> >>> Thanks >>> >>> Jerry >>> _______________________________________________ >>> time-nuts mailing list -- [email protected] >>> To unsubscribe, go to >>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >>> and follow the instructions there. >> >> _______________________________________________ >> time-nuts mailing list -- [email protected] >> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts >> and follow the instructions there. > > _______________________________________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
